Read Online or Download D80 repair manual PDF

Similar technique books

Nanoengineering of Structural, Functional and Smart Materials

During this choice of 24 articles, participants describe their learn within the improvement of multifunctional fabrics which are powerful, light-weight and flexible. in addition to functional info at the ways that they performed their paintings, participants additionally 5 details on functions in composite fabrics, electronics, biosensing and shrewdpermanent fabrics.

Machine Learning and Systems Engineering

A wide foreign convention on Advances in computing device studying and structures Engineering was once held in UC Berkeley, California, united states, October 20-22, 2009, less than the auspices of the area Congress on Engineering and machine technological know-how (WCECS 2009). desktop studying and structures Engineering includes forty-six revised and prolonged learn articles written through sought after researchers engaging within the convention.

Nanoreactor Engineering for Life Sciences and Medicine (Artech House Series Engineering in Medicine & Biology)

Nanoreactors are nanoscale automobiles for enzymes and sensors which are used to create actual and chemical reactions. Nanoreactor builders are at the cusp of impressive advances in clinical diagnostics and remedies, tissue engineering, and cellphone biology, and this authoritative source places bioengineers correct on the innovative.

Extra info for D80 repair manual

Sample text

Ref. Fig. ③ and ④) Note: Be careful not to bend contact blade of F-min SW. Fig. ① Fig. ② Aperture control unit #207 2 #203 1 Arm Fig. ③ #624×2 Fig. A AF driving unit ・Mount the AF motor PCB (#B172) by following the direction for positioning, and fix it with two screws (#637). A Vertical lever ・ Assemble by the following order. #122→#191→#630 #191 [#191] comes under when assembled. #630 Grease: LEN317A Note: Be careful NOT to bend contact blade of the lens release SW. #122 Horizontal lever #185 ・ Put the coupling shaft (#185).

Yellow wire ① Put two wires each on either side of the rib/protrusion. SB PCB ・ Solder six wires. ・ Connect the FPC to the connector. Blue wire: Main condenser Pink wire: Main condenser Red wire: DC/DC PCB Black wire: DC/DC PCB Yellow wire: DC/DC PCB Blue wire: DC/DC PCB FPC - A 23 ・ Blue wire - ③ Put each wire between bosses. A Main PCB unit ・ Mount the main PCB unit (#B1001). ・ Tighten two screws (#695). ・ Solder the two wires of the electronic buzzer unit. ・ Connect the main PCB-FPC (#B1001) to the connector of the DC/DC PCB.

A Aperture control unit Procedure 1. Remove two wires. Brown: Fmin SW 2. Take out two screws (#624) and one screw (#698). Black: Fmin SW 3. Press down the aperture lever with finger, and move the aperture coupling lever (#207) the direction of arrow ( ① ). 4. , while letting the arm of [#RP-B241] escape, remove the aperture control unit (#RP-B241) by pulling it in the direction indicated by arrow ( ② ). A AF driving unit Lens release button / Vertical lever / Horizontal lever areas ・ Remove the horizontal lever (#193), and remove the AF motor PCB (#B172).

Download PDF sample

Rated 4.35 of 5 – based on 42 votes